Attenuation Tank Liners
We recently supplied 2 panels x 25.5m wide x 28m long & 2 panels x 24m wide x 25m long of our Power Scrim 600 (4 layer composite reinforced membrane) to a repeat client for an attenuation tank liner application.
Two panels were deployed on the base requiring one weld prior to crate placement and then two panels, as seen in the photograph, are being prepared to be deployed as the lid, again one weld will be required followed by welding the lid to the base liner.
By supplying job specific sized pre-welded panels the total welding was reduced to two cross welds for the base and lid and then one weld around the perimeter to weld the lid to the base, a massive reduction in welding compared to welding every roll width on site and therefore providing a very significant cost saving!
We currently supply Power Scrim 600, 750 and 1000 for attenuation tank liner applications which are all 4 layer composite reinforced membranes, and from early 2019 we will also offer 0.75mm and 1mm PP in pre-welded panels (available up to 32m wide x 300m long) for attenuation tank and pond lining applications.